Manufacturer: Granberg International
Color: Orange, Silver
The Alaskan small log chain saw milling attachment is perfect for the woodworker, homeowner or carpenter. Compact, lightweight design bolts directly to the chain saw's bar without any drilling required. Handles up to (in.): 1/2-13 Thick, 17 wide, application: log milling attachment to cut lumber, works with: chainsaw up to 20 in. Bar.
The Niagara Cutter S203 uncoated (bright) high-speed steel square nose end mill provides the efficiency of two flutes and a 30-degree helix angle for general-purpose machining on a variety of materials. High-speed steel (HSS) is a common, general-purpose steel for cutting tools and is compatible with a variety of materials. With no coating or surface treatment, this uncoated tool can be used on a broad range of materials. The toolâ€™s square end has straight cutting edges that create sharp, unrounded cuts, while the center-cutting design has cutting teeth at the end of the tool that support making pocket cuts, profiling, and slotting. The end millâ€™s two flutes have better chip-carrying capacity than end mills with more flutes while offering additional support when the tool goes deep into the material in applications with a high depth of cut. The 30-degree helix angle supports general-purpose applications. It balances lower anglesâ€™ strong cutting edge for difficult-to-machine materials with higher anglesâ€™ increased cutting action. Cutting diameter tolerance is +0.001" to -0.000". The end mill has a Weldon shank. End mills are designed to remove material and create multi-dimensional shapes and profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. If heat is not reduced effectively, the toolâ€™s cutting edges will dull and additional material buildup can occur. The number of flutes can range from two to eight. Two-flute designs offer the most efficient chip removal, but more flutes provide a smoother finish. The shank is the end of the tool held in place by a tool holder or machine. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts. Niagara Cutter has been designing and manufacturing precision cutting ...
Manufacturer: Ann Way Machine Tools Co., Ltd
Metaltech, High Speed Collect Chuck Tool Holder ER+ 11, CAT40, 30.000 RPM 2.5G, 4 inch. H-CAT40-ER+11-4 | Balanced holder with a maximum speed of 30.000 rpm and 2.5 G. | Special nut with an improved design, the nut will fit internally into the holder, improving the cutting conditions and reducing the vibrations of the cutting tool. | Wrench is not included with the holder, it can be purchased separately. | This holder use the standard ER 11 collets. | Specifications: | Clamping Range: 1/32~1/4 in | Diameter (D): 0.75 in | Length (L): 4.00 in | Thread (G): M18x1P | Weight : 1.2 kg | Brand: Metaltech | Condition: New | Country of Origin: Taiwan |